General approach for the determination of the magneto-angular dependence of the critical current of YBCO coated conductors

The physical understanding and numerical modelling of superconducting devices which exploit the high performance of second generation high temperature superconducting tapes (2G-HTS), is commonly hindered by the lack of accurate functions which allow the consideration of the in-field dependence of the critical current. This is true regardless of the manufacturer of the superconducting tape. In this paper, we present a general approach for determining a unified function I $_{c}$(B, θ), ultimately capable of describing the magneto-angular dependence of the in-field critical current of commercial 2G-HTS tapes in the Lorentz configuration. Five widely different superconducting tapes, provided by three different manufacturers, have been tested in a liquid nitrogen bath and external magnetic fields of up to 400 mT. The critical current was recorded at 90 different orientations of the magnetic field ranging from θ = 0°, i.e., with B aligned with the crystallographic ab-planes of the YBCO layer, towards ±90°, i.e., with B perpendicular to the wider surfaces of the 2G-HTS tape. The whole set of experimental data has been analysed using a novel multi-objective model capable of predicting a sole function I $_{c}$(B, θ). This allows an accurate validation of the experimental data regardless of the fabrication differences and widths of the superconducting tapes. It is shown that, in spite of the wide set of differences between the fabrication and composition of the considered tapes, at liquid nitrogen temperature the magneto-angular dependence of the in-field critical current of YBCO-based 2G-HTS tapes, can be described by a universal function I $_{c}$($\textit{f}$(B), θ), with a power law field dependence dominated by the Kim's factor B/B $_{0}$, and an angular dependence moderated by the electron mass anisotropy ratio of the YBCO layer.This work was supported by the Engineering and Physical Sciences Research Council (EPSRC) project NMZF/064. X Zhang acknowledges a grant from the China Scholarship Council (No. 201408060080)

Experimental study of the normal zone propagation velocity in double-layer 2G-HTS wires by thermal and electrical methods

The Normal Zone Propagation Velocity (NZPV) of a double-layer second generation (2G) high temperature superconducting (HTS) wire manufactured by American Superconductor has been measured by electrical and thermal methods, and the results have been compared and discussed. The NZPV values determined by the voltage traces are ranging from 3.8 mm/s at 0.4 Ic to 19.2 mm/s at 0.9 Ic; while from 5.9 mm/s to 18.3 mm/s by the temperature traces. NZPV determined by these two approaches agrees well with each other. Also, NZPV of double-layer YBCO tape is close to that of conventional single-layer superconducting tape.This work was supported in part by the EPSRC under Grant NMZF/064.This is the accepted manuscript. The final version is available from IEEE at http://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=6963291&sortType%3Dasc_p_Sequence%26filter%3DAND%28p_IS_Number%3A6353170%29%26rowsPerPage%3D50

Investigation of demagnetization in HTS stacked tapes implemented in electric machines as a result of crossed magnetic field

This paper investigates the practical effectiveness of employing superconducting stacked tapes to superconducting electric machinery. The use of superconducting bulks in various practical applications has been addressed extensively in the literature. However, in practice, dramatic decrease in magnetization would occur on superconducting bulks due to the crossed field effect. In our study, we employed the superconducting stacked tapes in a synchronous superconducting motor, which was designed and fabricated in our laboratory, aiming to lessen demagnetization due to crossed field effect in comparison with superconducting bulks. Applying the transverse AC field, the effects of frequency, amplitude, and number of cycles of the transverse magnetic field are discussed. Furthermore, a stack of 16 layers of superconducting tapes is modelled and the consequences of applying the crossed magnetic field on the sample are evaluated. The confrontation between experiments and simulation allows us to thoroughly understand the crossed field effects on stacked tapes. At the end, a preventive treatment, based on the shielding characteristic of superconductor and materials with high permeability, i.e. -metal and metalic glass, is suggested. On the other hand, the shielding feature of aforementioned materials will hinder the penetration of magnetic field and, consequently, reduction of the demagnetization will be attained.This is the accepted manuscript. The final version is available from IEEE at https://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=6965587&sortType%3Dasc_p_Sequence%26filter%3DAND%28p_Publication_Number%3A77%29%26pageNumber%3D16

Optimal location and minimum number of superconducting fault current limiters for the protection of power grids

This paper presents a novel method to determine the optimal strategy for the allocation of multiple resistive superconducting fault current limiters (SFCLs) aiming to improve the overall protection of standard power grids. The presented approach allows for the straightforward determination of the optimal resistance of the SFCL, accounting for short circuit events occurring at different locations, by modelling the electro-thermal properties of the SFCL via a temperature dependent E-J power law. This material law, based on previous experimental evidence, allows for the introduction of flux pinning, flux creep, and flux flow properties of the superconducting material within a minimum level of complexity. Thereby, we have observed a distinctive kink pattern in the current limiting profiles of the SFCLs, from which no further reduction of the first peak of the fault current is achieved when a greater resistance is considered, allowing a univocal determination of the optimum SFCL resistance. This peculiarity is not observed when the model for the quench properties of the SFCL is simplified towards an exponential resistance, although the last can be used as an auxiliary process for addressing the first guess on the resistance value required for a specific strategy, as it demands less computing time. We have also determined that for many of the cases studied, i.e., for the combinations between one or more SFCLs installed at different locations, and those subjected to fault events located at different points in the network, the recovery time of the superconducting properties of at least one of the SFCLs can last for more than 5 min, constraining the feasibility of a large-scale deployment of this technology. However, by assuming that the practical operation of the SFCL is assisted by the automatic operation of a bypass switch when the SC material is fully quenched, we have determined that the optimal strategy for the overall protection of power grids of standard topology requires a maximum of three SFCLs, with recovery times of less than a few seconds. This information is of remarkable value for power system operators, as it can establish a maximum investment threshold which ultimately can facilitate making decisions regarding the deployment of SFCL technologies.This work was supported by the Engineering and Physical Sciences Research Council (EPSRC) project NMZF/064. X. Zhang acknowledges a grant from the China Scholarship Council (No. 201408060080)

Critical current studies of a HTS rectangular coil

Nowadays, superconducting high field magnets are used in numerous applications due to their superior properties. High temperature superconductors (HTS) are usually used for production of circular pancake or racetrack coils. However different geometries of HTS coils might be required for some specific applications. In this study, the HTS coil wound on a rectangular frame was fully characterized in homogeneous DC background field. The study contains measurements of critical current angular dependencies. The critical current of the entire coil and two selected strands under different magnitudes and orientations of external magnetic fields are measured. The critical regions of the coil in different angular regimes are determined. This study brings better understanding of the in- field performance of HTS coils wound on frames with right-angles

Study protocol of cost-effectiveness and cost-utility of a biopsychosocial multidisciplinary intervention in the evolution of non-specific sub-acute low back pain in the working population: cluster randomised trial.

This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.Background: Low back pain (LBP), with high incidence and prevalence rate, is one of the most common reasons to consult the health system and is responsible for a significant amount of sick leave, leading to high health and social costs. The objective of the study is to assess the cost-effectiveness and cost-utility analysis of a multidisciplinary biopsychosocial educational group intervention (MBEGI) of non-specific sub-acute LBP in comparison with the usual care in the working population recruited in primary healthcare centres. Methods/design: The study design is a cost-effectiveness and cost-utility analysis of a MBEGI in comparison with the usual care of non-specific sub-acute LBP.Measures on effectiveness and costs of both interventions will be obtained from a cluster randomised controlled clinical trial carried out in 38 Catalan primary health care centres, enrolling 932 patients between 18 and 65 years old with a diagnosis of non-specific sub-acute LBP. Effectiveness measures are: pharmaceutical treatments, work sick leave (% and duration in days), Roland Morris disability, McGill pain intensity, Fear Avoidance Beliefs (FAB) and Golberg Questionnaires. Utility measures will be calculated from the SF-12. The analysis will be performed from a social perspective. The temporal horizon is at 3 months (change to chronic LBP) and 12 months (evaluate the outcomes at long term. Assessment of outcomes will be blinded and will follow the intention-to-treat principle. Discussion: We hope to demonstrate the cost-effectiveness and cost-utility of MBEGI, see an improvement in the patients' quality of life, achieve a reduction in the duration of episodes and the chronicity of non-specific low back pain, and be able to report a decrease in the social costs. If the intervention is cost-effectiveness and cost-utility, it could be applied to Primary Health Care Centres. Trial registration: ISRCTN: ISRCTN5871969

Doctors and nurses benefit from interprofessional online education in dermatology

<p>Abstract</p> <p>Background</p> <p>Benefits of online learning in the health sector have been demonstrated in previous studies. We examined the potential benefits of a joint web-based curriculum on atopic eczema for health personnel.</p> <p>Methods</p> <p>Enrolled doctors and nurses had access to the curriculum for 8 weeks. After the course learners completed a questionnaire. Two dermatologists rated the quality of the submitted homework assignments. Based on data from the project's budget and the Norwegian Medical Association, we estimated the saved travel expenses.</p> <p>Results</p> <p>Eighty-eight learners (46 doctors) registered for the course. We received 55 questionnaires (response rate 63%). Twenty-seven learners (31%; 16 doctors, 11 nurses; χ²= 0.03; P = 0.87) used the discussion forum. We found no significant differences in the total questionnaire scores between doctors and nurses. The homework assignments were given an average score of 3.6 for doctors and 3.5 for nurses (P = 0.8) by rater 1. Rater 2 scored 3.9 and 3.6 for doctors and nurses respectively (P = 0.2). The break-even between travel/hotel expenses and course development costs occurred at 135 saved travel refund applications.</p> <p>Conclusions</p> <p>Doctors and nurses were equally satisfied with a joint web-based course on atopic eczema. The use of an online discussion forum was limited but similar between doctors and nurses. There were no significant differences in the quality of submitted homework assignments. The cost of developing the course was 716 841 NOK and the first 86 learners saved 455 198 NOK in travel expenses.</p

Evidence of the Importance of Host Habitat Use in Predicting the Dilution Effect of Wild Boar for Deer Exposure to Anaplasma spp

Foci of tick-borne pathogens occur at fine spatial scales, and depend upon a complex arrangement of factors involving climate, host abundance and landscape composition. It has been proposed that the presence of hosts that support tick feeding but not pathogen multiplication may dilute the transmission of the pathogen. However, models need to consider the spatial component to adequately explain how hosts, ticks and pathogens are distributed into the landscape

Bcl-2 protein family: Implications in vascular apoptosis and atherosclerosis

Apoptosis has been recognized as a central component in the pathogenesis of atherosclerosis, in addition to the other human pathologies such as cancer and diabetes. The pathophysiology of atherosclerosis is complex, involving both apoptosis and proliferation at different phases of its progression. Oxidative modification of lipids and inflammation differentially regulate the apoptotic and proliferative responses of vascular cells during progression of the atherosclerotic lesion. Bcl-2 proteins act as the major regulators of extrinsic and intrinsic apoptosis signalling pathways and more recently it has become evident that they mediate the apoptotic response of vascular cells in response to oxidation and inflammation either in a provocative or an inhibitory mode of action. Here we address Bcl-2 proteins as major therapeutic targets for the treatment of atherosclerosis and underscore the need for the novel preventive and therapeutic interventions against atherosclerosis, which should be designed in the light of molecular mechanisms regulating apoptosis of vascular cells in atherosclerotic lesions

Reuse of terminological resources for efficient ontological engineering in Life Sciences

This paper is intended to explore how to use terminological resources for ontology engineering. Nowadays there are several biomedical ontologies describing overlapping domains, but there is not a clear correspondence between the concepts that are supposed to be equivalent or just similar. These resources are quite precious but their integration and further development are expensive. Terminologies may support the ontological development in several stages of the lifecycle of the ontology; e.g. ontology integration. In this paper we investigate the use of terminological resources during the ontology lifecycle. We claim that the proper creation and use of a shared thesaurus is a cornerstone for the successful application of the Semantic Web technology within life sciences. Moreover, we have applied our approach to a real scenario, the Health-e-Child (HeC) project, and we have evaluated the impact of filtering and re-organizing several resources. As a result, we have created a reference thesaurus for this project, named HeCTh